宇航计测技术 ›› 2022, Vol. 42 ›› Issue (6): 41-46.doi: 10.12060/j.issn.1000-7202.2022.06.07

• 精密测试技术 • 上一篇    下一篇

基于圆光栅和加窗FFT的低频角振动测量方法

金冉，陈永久，张军，朱永晓，厉巍   

  1. 贵州航天计量测试技术研究所，贵阳 550009
  • 出版日期:2022-12-25 发布日期:2023-02-07
  • 作者简介:金冉(1989-)，男，高级工程师，硕士，主要研究方向：力学计量技术。

Measurement Method of Low Frequency Angular Vibration Using Circular Grating and Windowed FFT

JIN Ran，CHEN Yong-jiu，ZHANG Jun，ZHU Yong-xiao，LI Wei   

  1. Gui Zhou Aerospace Institute of Measuring and Testing Technology,Guiyang 550009,China
  • Online:2022-12-25 Published:2023-02-07

PDF (PC)

144

摘要： 通过对角振动参数测量在惯性和动态扭矩校准领域的应用研究，提出了基于圆光栅和加窗FFT的角振动测量及数据分析方法。通过高速数据采集卡对圆光栅传感器输出的信号进行采集和存储，通过电平累加得到波形轮廓，再对合成波形抽样并进行加窗FFT计算，最后得到角加速度参数。用标准角振动台对测量装置进行测试，并对测量结果进行不确定度评定。试验结果表明，该方法测得的角加速度值与标准值的相对误差小于2.5%，重复性小于0.3%，具有工程应用价值。

关键词: 振动与波, 角振动, 角加速度, 圆光栅, 加窗FFT

Abstract: Through studying the measurement of angular vibration parameter in the field of inertia and dynamic torque calibration.An angular vibration measurement and data analysis method using circular grating and windowed FFT is proposed.Firstly,collecting and storing the signal the circular grating sensor output by the high-speed data acquisition card,through the way of level accumulation obtaining the waveform contour.Then the synthetic waveform is sampled and which is calculated by windowed FFT.Finally,the angular acceleration parameters are obtained.An experiment is designed to test the measuring device with a standard angle shaking table,the experimental results show that the relative error between the angular acceleration measured by this method and the standard value is less than 2.5%，and the repeatability of angular acceleration is less than 0.3%，and the the uncertainty of the measurement results is evaluated.

Key words: Vibration and wave, Angular vibration, Angular acceleration, Circular grating, Windowed FFT

中图分类号: 

京ICP备09048426号-4　 京公网安备 11010602060144号　版权所有 © 《宇航计测技术》编辑部