伺服系统用反馈电位计故障分析及对策

doi:10.12060/j.issn.1000-7202.2015.06.17

宇航计测技术 ›› 2015, Vol. 35 ›› Issue (6): 77-81.doi: 10.12060/j.issn.1000-7202.2015.06.17

伺服系统用反馈电位计故障分析及对策

甘霖¹；李文璋¹；崔新宇¹

1、北京精密机电控制设备研究所，北京 100076

出版日期:2015-12-15 发布日期:2015-12-15
作者简介:甘霖（1984-），男，硕士研究生，工程师，主要研究方向：伺服电子测量设计。

Analysis and Countermeasures of the Fault for Feedback Potentionmeters in Servo System

GAN Lin¹；LI Wen-zhang¹；CUI Xin-yu¹

1、Beijing Research Institute of Precise Mechanical and Electronic Control Equipment , Beijing 100076

Online:2015-12-15 Published:2015-12-15

摘要/Abstract

摘要： 电位计以其结构简单，性能稳定，能适应恶劣环境等特点，广泛应用于伺服系统中。然而在使用过程中时常出现输出信号异常或中断，使伺服系统性能下降或无法正常工作，严重影响伺服系统的使用。根据多年来伺服系统用反馈电位计的应用情况得知，引起电位计输出信号异常的故障原因主要有电刷断裂、铆钉松动、垫片断裂、引出线断裂、电刷与中心抽头银带接触以及电阻膜或导电条表面有异物或瑕疵点等。通过故障模式机理分析确定了故障的原因，给出了控制和消除故障的方法与建议，并应用于反馈电位计产品整个研制生产过程中，从而提高了伺服系统的可靠性和安全性。

关键词: 伺服系统, 电位计, 故障分析

Abstract:

Potentiometer with simple structure, stable performance, adapting bad environment characteristics, widely was used in servo system. However, the unusual and interrupt of potentiometer output signal caused the servo system performance degradation or not work, even seriously impacted on the use of servo system. According to the application situation of feedback potentiometer in the servo system over the years, the reason of potentiometer output abnormal mainly were brush fracture, loosen rivets, gasket rupture, wire fracture, join between brush and the center silver belt , having excess or defects on the surface of resistance film and conductive strip etc. The cause of the failure was determined by the failure mode analysis. The suggestions and methods of eliminating faults were presented, and were applied in the production process of feedback potentiometer. Thus the reliability and safety of the servo system have been improved.

Key words: Servo system , Potentiometers, Fault analysis

甘霖；李文璋；崔新宇. 伺服系统用反馈电位计故障分析及对策[J]. 宇航计测技术, 2015, 35(6): 77-81.

GAN Lin；LI Wen-zhang；CUI Xin-yu. Analysis and Countermeasures of the Fault for Feedback Potentionmeters in Servo System[J]. JOURNAL OF ASTRONAUTIC METROLOGY AND MEASUREMENT, 2015, 35(6): 77-81.

[1]	李宏伟, 陈海建, 汪洋. Kalman 滤波算法在遥测伺服系统中的应用[J]. 宇航计测技术, 2018, 38(5): 66-71.
[2]	丛书全；陈剑涛. 基于机械干涉理论估算无人机舵机电位计磨损可靠工作设计[J]. 宇航计测技术, 2016, 36(2): 72-75.
[3]	郭薇妮；李梦雪；李丹佳. 一种改进型导电塑料电位计研制[J]. 宇航计测技术, 2016, 36(1): 52-56.
[4]	李沛剑；朱廷伟；包婷萍. 高温小型化转速传感器研制[J]. 宇航计测技术, 2013, 33(6): 17-19.
[5]	崔玉江；王伟；杨明；甘霖；王彦奎. 伺服反馈位移传感器的现状及发展趋势[J]. 宇航计测技术, 2012, 32(4): 65-68.

伺服系统用反馈电位计故障分析及对策

Analysis and Countermeasures of the Fault for Feedback Potentionmeters in Servo System

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 5

编辑推荐

Metrics

本文评价